Vinyl Care
How to take care of my wrapped vehicle?
You would want to care for your vinyl wrap on the vehicle the same way as for your car paint.
Hand washing is always the best and safest choice!
Only touch-less car washes are recommended. Car washes that have the rotating brushes may lift and remove the vinyl!
For best cleaning and maintaining of the finish as well as protecting against fading we recommend using PH Balanced products.
Hand Wash
Wash whenever the car appears dirty. Contaminants allowed to remain on the vehicle wrap may be more difficult to remove during cleaning.
Rinse off as much dirt and grit as possible with a spray of water.
Use a wet, non-abrasive detergent such and a soft, clean cloth or sponge.
Rinse thoroughly with clean water. To reduce water spotting, immediately use a clean microfiber cloth or any drying towel to remove water.
Automated Car Washes
Use touch-less car washes (car wash using water jets only without brushes) if you don’t have time for a hand-wash. Brush-type car washes are not recommended as they can scratch the film, cause edges to lift or chip, and dull the film’s appearance.
Pressure Washing
Although hand washing is the preferred cleaning method, pressure washing may be used under these conditions.
Ensure the water pressure is kept below 2000 psi (14 MPa).
Keep water temperature below 80°C (180°F).
Use a spray nozzle with a 40 degree wide angle spray pattern.
Keep the nozzle at least 1 foot (300 mm) away from and perpendicular (at 90 degrees) to the graphic.
Important Note! Holding the nozzle of a pressure washer at an angle to the graphic may lift the edges of the film.
Difficult Contaminants
Soften difficult contaminants such as bug splatter, bird droppings, tree sap and similar contaminants by soaking them for several minutes with very hot, soapy water. Rinse thoroughly and dry. Spot clean the contaminants. Do not use rough scrubbing, dirty or abrasive tools, which will scratch the film. Wash and rinse off all residue immediately.
Fuel Spills – Wipe off immediately to avoid degrading the vinyl and adhesive. Then wash, rinse and dry as soon as possible.
Film Restoration
The following restoration recommendations will help keep your vehicle wraps looking their best.
Do not use any abrasive polishes or cutting compounds
Do not use any polishing or wax products on matte or textured films
If there is paste wax or wax residue on the surface, remove with an all-purpose cleaner
Before using cleaning products, always test and approve in an inconspicuous area